This paper is published in Volume-3, Issue-3, 2017
Area
Mechanical Engineering
Author
Saiyed Faiyaz
Co-authors
Mrs. J. G. Borke
Org/Univ
Shri Shankarprasad Agnihotri College Of Engineering, Wardha, Maharashtra, India
Pub. Date
16 May, 2017
Paper ID
V3I3-1333
Publisher
Keywords
Resistance spot welding (RSW), S/N Ratio, Taguchi method, optimization, tensile strength

Citationsacebook

IEEE
Saiyed Faiyaz, Mrs. J. G. Borke. The Experimental Investigation and Analysis of Spot Welding Process Parameters for Maximum Tensile Strength, International Journal of Advance Research, Ideas and Innovations in Technology, www.IJARIIT.com.

APA
Saiyed Faiyaz, Mrs. J. G. Borke (2017). The Experimental Investigation and Analysis of Spot Welding Process Parameters for Maximum Tensile Strength. International Journal of Advance Research, Ideas and Innovations in Technology, 3(3) www.IJARIIT.com.

MLA
Saiyed Faiyaz, Mrs. J. G. Borke. "The Experimental Investigation and Analysis of Spot Welding Process Parameters for Maximum Tensile Strength." International Journal of Advance Research, Ideas and Innovations in Technology 3.3 (2017). www.IJARIIT.com.

Abstract

This experimental study is based on an investigation of the effect of welding parameters on tensile shear strength in the resistance spot welding (RSW) process and optimization of welding parameters. The experiment conducted under varying parameters like forces, currents and weld times without disturbing water flow and room temperature. The setting of welding parameters was determined by using Taguchi experimental design of L9 orthogonal array method. The combination of the optimum welding parameters have determined by using analysis of Signal- to- Noise (S/N) rario. The experimental result clearly shows that it is possible to increase tensile shear strength of a joint by the combination of suitable welding parameters. Hence the experimental result proved the validity of the used taguchi method for enhancing the welding strength performance and optimizing the most suitable welding parameters in resistance spot welding operations.
Paper PDF