8,100+ papers published18,500+ authors published44 countriesPublishing since 2014

Manuscripts

Recent Papers

Power Quality Improvement of Three Phase System Using Shunt Active Power Filter

Abstract— A power quality issue basically deals with any occurrence manifested in current, voltage or frequency deviation that results in damage, upset or failure of end use equipment. The non-linearity in the properties of power electronics devices and the higher switching frequency are the main causes of power quality issue. Thus this paper deals with power quality improvement by shunt active power filter to eliminate voltage and load current harmonics and for reactive power compensation. A shunt active power filter based on the instantaneous active and reactive current component (Id – Iq) method is proposed to compensate first harmonic unbalance. A theoretical study based on synchronous detection method is done in this paper and the simulation results are analyzed regarding the harmonics compensation. Simulations are carried out with PI controller for the (Id – Iq) control strategies for different voltage condition using MATLAB/ SIMULINK.

Published by: Niklesh Das, Sandeep Mude

Author: Niklesh Das

Paper ID: V3I2-1164

Paper Status: published

Published: March 6, 2017

Full Details

Performance Evaluation of Advanced STBC MIMO Wireless Communication System with Channel Estimation Based Block Coding

This paper presents the design of microstrip patch antenna using high-frequency structure simulator (HFSS 12). The two different configurations S-slot & C-slot rectangular patches are designed. The performance of two antennas is analyzed in terms of bandwidth, return loss and gain. The material used for the substrate is FR4 having the dielectric constant 4.4. This material is easily available & has low cost. The return loss of S slot rectangular patch is -36.53db & the gain is 5.3009 db whereas the return loss for C slot is -34.99 db and gain is 4.8762 db.

Published by: Ayushi Aggarwal, Bindia

Author: Ayushi Aggarwal

Paper ID: V3I2-1163

Paper Status: published

Published: March 6, 2017

Full Details

Electrical Current Signature Analysis

Induction motors have become the “horse-power” of industry and are the most widely used electrical machines. They can typically consume between 50 to 60% of all the generated capacity of any industrialized nation. This article focuses on the industrial application of Electrical Current Signature Analysis (ECSA) to diagnose faults in an induction motor drives. ECSA is a non-invasive, on-line monitoring technique for the diagnosis of problems in induction motors. Reliability based maintenance (RBM) and condition- based maintenance (CBM) strategies are now widely used by industry, and health monitoring of electrical drives is a major feature in such programs

Published by: Abhishek Singh, Deepak Singh, Narendra Singh, Pulkit Gupta, Mr. Piyush Agnihotri

Author: Abhishek Singh

Paper ID: V3I2-1158

Paper Status: published

Published: March 6, 2017

Full Details

Designing and Performance Evaluation of S and C Slot Rectangular Microstrip Patch Array Antenna

This paper presents the design of microstrip patch antenna using high frequency structure simulator (HFSS 12). The two different configurations S-slot & C-slot rectangular patches are designed. The performance of two antennas is analyzed in terms of bandwidth, return loss and gain. The material used for substrate is FR4 having the dielectric constant 4.4. This material is easily available & has low cost. The return loss of S slot rectangular patch is -36.53db & gain is 5.3009 db whereas the return loss for C slot is -34.99 db and gain is 4.8762 db.

Published by: Bindia, Ayushi Aggarwal

Author: Bindia

Paper ID: V3I2-1162

Paper Status: published

Published: March 6, 2017

Full Details

Meta Modeling Using Prediction Correlation for Solar Powered Battery Charge- Discharge System for a Wireless Sensor Node

Wireless sensor nodes to be powered continuously for long life, good performance and high accuracy in the unattended location of the world. Battery powered sensor nodes are not able to provide continuous power. solar power is the scavenge source, but due to the sun cycle variation, it is important to predict the solar current energy produced according to time. In this paper we use automatic battery charger -discharge system that uses the meta-modeling correlation for prediction of solar energy and processor is designed for powering wireless sensor node. The new method uses simple kriging model and swarms optimization that improves precharge time by 61.54% while speeding up the process by390*. The simulation results are shown by MATLAB, labview, and design of the processor with EDA tools.

Published by: Dr. Ashok .J, Ms. Pradnya P. Mirajkar

Author: Dr. Ashok .J

Paper ID: V3I2-1159

Paper Status: published

Published: March 6, 2017

Full Details
Review Paper

Survey on Different Approaches of Detection of Gray Hole Attack in MANET

The fundamental problems of ad hoc network by giving its related research background including the concept, features, status, and vulnerabilities of MANET. They also present an overview and the study of the routing protocols. Also include the several challenging issues, emerging application and the future trends of MANET. As the popularity of mobile device and wireless networks significantly increased over the past years, wireless ad-hoc networks have now become one of the most vibrant and active fields of communication and networks. In this paper review the different technology of MANET.

Published by: Geetanjali, Jyoti Gupta

Author: Geetanjali

Paper ID: V3I2-1155

Paper Status: published

Published: March 4, 2017

Full Details