This paper is published in Volume-6, Issue-5, 2020
Area
Unconventional Machining
Author
Venkat Lalit Shukla, Dr. S. K. S. Yadav
Org/Univ
Harcourt Butler Technical University, Kanpur, Uttar Pradesh, India
Pub. Date
04 September, 2020
Paper ID
V6I5-1145
Publisher
Keywords
Wire EDM, ABAQUS CAE, Meshing, Finite Element Method

Citationsacebook

IEEE
Venkat Lalit Shukla, Dr. S. K. S. Yadav. Thermal modelling of spark in wire cut EDM, International Journal of Advance Research, Ideas and Innovations in Technology, www.IJARIIT.com.

APA
Venkat Lalit Shukla, Dr. S. K. S. Yadav (2020). Thermal modelling of spark in wire cut EDM. International Journal of Advance Research, Ideas and Innovations in Technology, 6(5) www.IJARIIT.com.

MLA
Venkat Lalit Shukla, Dr. S. K. S. Yadav. "Thermal modelling of spark in wire cut EDM." International Journal of Advance Research, Ideas and Innovations in Technology 6.5 (2020). www.IJARIIT.com.

Abstract

Wire EDM is a non-contact machining process of contouring different intricate shapes from bulk material. The phenomenon behind material removal is high temperature due to spark in the wire the material melts and vapours. This process enables the manufacturer to fabricate new high-temperature resistive material. The wire is made of brass on which the analysis has been carried out. The existing work deals with Thermal modelling of spark using ABAQUS CAE software. The material of wire considered is brass. Heat transfer is transient in nature due very small time available to single spark. The variation of heat flux and temperature were analyzed by results obtained from modelling.