This paper is published in Volume-4, Issue-3, 2018
Area
Mechanical Engineering
Author
Santosh Kumar Choudhary, Susheel Malviya, Sachin Jain
Org/Univ
Bansal Institute of Science and Technology, Bhopal, Madhya Pradesh, India
Pub. Date
11 June, 2018
Paper ID
V4I3-1851
Publisher
Keywords
Fused deposition modelling, PLA, Layer thickness, Raster angle, ANOVA and Taguchi method

Citationsacebook

IEEE
Santosh Kumar Choudhary, Susheel Malviya, Sachin Jain. Experimental investigation on the process parameter of rapid prototyping technique for the improvement of disposal glass material replace by PLA, International Journal of Advance Research, Ideas and Innovations in Technology, www.IJARIIT.com.

APA
Santosh Kumar Choudhary, Susheel Malviya, Sachin Jain (2018). Experimental investigation on the process parameter of rapid prototyping technique for the improvement of disposal glass material replace by PLA. International Journal of Advance Research, Ideas and Innovations in Technology, 4(3) www.IJARIIT.com.

MLA
Santosh Kumar Choudhary, Susheel Malviya, Sachin Jain. "Experimental investigation on the process parameter of rapid prototyping technique for the improvement of disposal glass material replace by PLA." International Journal of Advance Research, Ideas and Innovations in Technology 4.3 (2018). www.IJARIIT.com.

Abstract

This work proposes to characterize the influence of the physical build parameters over the part quality. An L9 orthogonal array was designed with the minimum number of experimental runs with desired parameter settings and also by analysis tools such as ANOVA (analysis of variance). Establishment of experimentally verified correlations between the physical part characteristics and mechanical part characteristics to obtain an optimal process parameter level for the betterment of part quality is obtained. The process model obtained by the empirical relation can be used to determine the strength of the prototype for the given set of parameters that shows the dependency of strength, which is essential for designers and RP machine users. It was concluded that layer thickness has a significant influence on physical and mechanical properties of PLA. The results show that only layer thickness is the most significant factor