This paper is published in Volume-12, Issue-6, 2026
Area
Mechanical Engineering
Author
Arun Ramachandran, Sree vidya T R
Org/Univ
Brandenburg Technical University, Cottbus, Germany, India
Pub. Date
17 November, 2026
Paper ID
V12I6-1156
Publisher
Keywords
Battery Thermal Management, Lithium-Ion Battery, Porous Aluminium, Forced-Air Cooling, Thermal

Citationsacebook

IEEE
Arun Ramachandran, Sree vidya T R. Thermal Performance Enhancement of Battery Systems using Porous Media with Optimized Layer Distribution, International Journal of Advance Research, Ideas and Innovations in Technology, www.IJARIIT.com.

APA
Arun Ramachandran, Sree vidya T R (2026). Thermal Performance Enhancement of Battery Systems using Porous Media with Optimized Layer Distribution. International Journal of Advance Research, Ideas and Innovations in Technology, 12(6) www.IJARIIT.com.

MLA
Arun Ramachandran, Sree vidya T R. "Thermal Performance Enhancement of Battery Systems using Porous Media with Optimized Layer Distribution." International Journal of Advance Research, Ideas and Innovations in Technology 12.6 (2026). www.IJARIIT.com.

Abstract

Lithium-ion batteries generate heat during high-rate operation, and inadequate heat removal can accelerate degradation and increase safety risks. This study numerically investigates forced-air cooling of cylindrical lithium-ion cells with porous aluminium media distributed around the cell surface. Configurations with no porous media and with 3, 5, and 7 porous layers are compared, followed by an assessment of asymmetric layer arrangements in a three-cell inline system. The reported single-cell maximum temperature decreases from approximately 31.86 °C without porous media to 30.76 °C, 30.37 °C, and 30.05 °C for the 3-, 5-, and 7-layer cases, respectively. In the multi-cell study, downstream cells experience higher temperatures because the cooling air warms along the flow direction. The study identifies a non-uniform layer distribution as a promising design approach: fewer layers can be used near the inlet, while additional layers can be assigned to downstream cells. Porous media increases the reported pressure drop by approximately 40% relative to the baseline, so thermal benefits must be assessed alongside flow resistance. These results indicate that porous aluminium combined with forced air can improve battery temperature control, while layer-wise optimization may balance cooling performance and structural complexity.